MKY's wiki

Ta strona jest tylko do odczytu. Możesz wyświetlić źródła tej strony ale nie możesz ich zmienić.
====== Prusa Slicer ======

Start G-code:  --- //2020.08.30//
<code>
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
M104 S[first_layer_temperature]; set extruder temp
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F[travel_speed] ;move the platform down 15mm
G92 E0 ; zero the extruded length
M109 S[first_layer_temperature]; wait for extruder temp
G1 F200 E15 ; extrude 15mm of feed stock
G92 E0 ; zero the extruded length again
G1 F[travel_speed]
M117 Printing...
G5
</code>

End G-Code:  --- //2020.08.30//
<code>
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M84 ; disable motors
M107 ; Fan Off
G91 ;relative positioning
G1 E-1 F3600 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 F2000 ;move Z up a bit
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
; G1 Y180 F2000
M84 ;steppers off
G90 ; absolute positioning
G0 Z200 F2000 ; move bed down
M84 ;steppers off
M300 P300 S4000 ; End Tone
</code>

==== Changelog ====

  * 2020.08.30
    * Print Settings
      * PLA
        * Speed
          * Speed for print moves //(zalecane przez producenta)//
            * Perimeters: **50mm/s**
            * Infill: **50mm/s**
            * Support material: **50mm/s**
            * Bridges: **50mm/s**
          * Speed for non-print moves
            * Travel: **60mm/s**
        * Advanced
          * Extrusion width //(znalezione na Reddit)//
            * Default extrusion width: **0.45mm**
            * First layer: **0.42mm**
            * Perimeters: **0.45mm**
            * External perimeters: **0.45mm**
            * Infill: **0.45mm**
            * Solid infill: **0.45mm**
            * Top solid infill: **0.4mm**
            * Support material: **0.35mm**

  * 2020.08.29
    * Print Settings
      * PLA
        * Support material
          * Interface pattern spacing: **0mm** (default) --> **1mm** (żeby było łatwiej oderwać support)